ACT Safety Switch Sys. Dual Battery
With the demands that modern high power, high torque servos put on the
rest of the airborne pack, it’s a surprising fact that the typical R/C switch
harness has remained unchanged. Many are unable to withstand the rigours
of today’s requirements and it is this reason that the switch can fail.
Mechanical wear and tear, vibration and fuel contact can lead to such a
failure. The wire diameter in a typical switch harness is often too small. The
Safety Switch System removes these problems. A key switch is pressed for
on, the electronics turn on, then the keypad is disabled. The electronics
remain switched on for approximately 2 minutes even if there is a temporary
interruption in the power supply. To switch off, the OFF keyswitch is pressed.
P-ACT554006 15A
Uses high current connectors & heavy duty wire for. Also ideal for use in
pairs when connecting two nicads to a DUO Batt for the ultimate high
power, high security solution.
Low internal resistance
Vibration/wear is almost eliminated
LED visual display when switched on
Essential for all large or valuable models.
