ACT Safety Switch System 10A
With the demands that modern high power, high torque servos put on the
rest of the airborne pack, it’s a surprising fact that the typical R/C switch
harness has remained unchanged. Many are unable to withstand the rigours
of today’s requirements and it is this reason that the switch can fail.
Mechanical wear and tear, vibration and fuel contact can lead to such a
failure. The wire diameter in a typical switch harness is often too small. The
Safety Switch System removes these problems. A key switch is pressed for
on, the electronics turn on, then the keypad is disabled. The electronics
remain switched on for approximately 2 minutes even if there is a temporary
interruption in the power supply. To switch off, the OFF keyswitch is pressed.
P-ACT554007 10A
Uses high power connectors on the battery side and split connectors to the
receiver to share the power handling.
An additional lead replaces the lost
receiver channel.
